Shenlingwushi123
- Total activity 10
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2
Activity overview
Latest activity by Shenlingwushi123-
Shenlingwushi123 commented,
I have tried this method. The two slave cameras work normally, and there are no prompt No Frames Received. But they look like they have not received the synchronization signal and receive the frame...
-
Shenlingwushi123 commented,
I just tried the method you mentioned.When I set the Inter Cam Sync Mode of the slave camera to 0 (unsynced) and run at fps of 90, they all work normally. This should indicate that there is no prob...
-
Shenlingwushi123 commented,
Thank you for your patient answers and links. I have carefully read all the documents you recommended to me, which is very helpful to me.I may not describe my problem clearly. I connected the circu...
-
Shenlingwushi123 commented,
When I use genlock mode (set the master to 1 and the remaining two slave cameras to 4), I found that the two slave cameras did not receive the frame, which should indicate that my circuit is not co...
-
Shenlingwushi123 commented,
Thank you for your detailed reply. Through your reply, I have successfully connected the camera (one master and two slaves).I want to ask three questions:(1) I used set_option(rs.option.exposure, 3...
-
Shenlingwushi123 commented,
Hi MartyG Thank you for your detailed reply.I don’t know much about hardware, so I would like to ask some more specific questions about the above question 1. 1. About this picture. My situation is...
-
Shenlingwushi123 created a post,
How to get the same timestamp data from two cameras
Camera Model D435i Firmware Version 05.12.08.200 Operating System & Version Win 10 Language Python3.7 SDK Version 2.39.0 Hi I have two D435i cameras. I'm currently working on a projec...
-
Shenlingwushi123 created a post,
About .bag file
Hi I'm currently researching to extract the depth information of a specific point (x,y) from the bag file. I want to ask two questions. 1. I used “config.enable_record_to_file(path)” when recording...